ENGLISH
-
Unscrew the 2 screws on the battery compartment, remove the battery cover and the
battery. Fig. 48
-
Insert the new battery with the battery label facing up. Fig. 49
-
Place the battery and the battery cover in its place and fix properly the screws back again.
5. TROUBLESHOOTING
Robot signal
Steady red light
Oscillating red
light
50
05660_Conga 1990 Connected_IM_YV_0121085.indd 50
05660_Conga 1990 Connected_IM_YV_0121085.indd 50
Cause
1 beep
Omnidirectional wheel
error.
2 beeps
Robot's side brush error
3 beeps
Motor fan or filter error
4 beeps
Main brush error
2 beeps
Bumper error
Free-fall sensor error
3 beeps
Solution
Clean the omnidirectional
wheel and press the power
button to restart.
Clean the side brushes and
press the power button to
restart the robot.
Remove and empty the
dust tank.
Remove the robot's filter
and shake off any dust
rests.
Remove and clean the
robot's dust tank.
Check if the bumper is
blocked and press on
both sides and center to
unblock it.
Check if the robot is placed
on an uneven surface, if its
wheels are off the ground
or if it is stuck in a dark
place and move it to a new
location. Otherwise, clean
the free-fall sensor.
6/8/21 13:08
6/8/21 13:08