Before Operating; While Operating - VITO PRO POWER VIBE1050A Manual De Instrucciones

Keep the power cord and plug away from heat sources, oil,
sharp objects and rotating accessories. Check the condition of
the power cord regularly; if it is damaged, it must be replaced
by a qualified technician; repairing it is not permitted.
Never modify the power cord plug and use a socket compatible
with the plug. Do not use any kind of adapter.
The use of extension cords for connecting the power cord is not
recommended. However, if you use an extension cord, you
should take some care, such as:
▪ If you use the electric tool outdoors, use only appropriate
extension cords for outdoor use. The use of an adequate
extension cord reduces the risk of electric shock;
▪ Use only extension cords, plugs and sockets with connection
or earth contact;
▪ The cable section of the extension cord shall be proportional
to the length and with characteristics equal to or greater
than the power cord of the power tool;
▪ Do not use damaged extension cords. Examine the extension
cord condition before using it and replace if necessary;
▪ Always disconnect the extension cords of the socket before
removing the plug from the power tool;
▪ When you have extension cord reels, unroll the cord
completely;

Before operating

Make sure that the machine is only used by who is familiar with
the instruction manual.
To ensure a safe operation, you must:
▪ Check the power tool before using it. Check that all the
accessories are correctly assembled and attached to the
machine and in good conditions. If there is damage or
excessive wear, replace the accessories;
▪ Check that all fixing screws are properly tightened. It is
important to check regularly to ensure the safety and
performance of the power tool;
▪ After assembling the accessories and before using the tool
on a part, perform a test at maximum speed without load for
some time. Check for misalignments in the moving parts or
any other condition that may affect the operation of the tool.
Check that all moving parts rotate smoothly, without
abnormal noise and sparks on the carbon brushes;
▪ Check that the safety devices are in perfect condition and
function correctly. Never use the power tool if the safety
devices are missing, inhibited, damaged or worn out;
▪ Make sure that the switch is off when you plug in the power
cord. If the button is damaged or doesn't allow to control the
machine's operation, it must be repaired or replaced in order
to prevent an unintentional start;
Make all necessary adjustments and work for the correct
installation of the electric tool, if you have doubts or difficulties,
go to your official dealer.

While operating

Keep other people away from the workspace. Never use
the machine if animals or people, particularly children,
are nearby.
Keep the workspace clean, organized and well illuminated
(luminosity from 250 to 300 lux), in order to reduce the risk of
accidents.
Always wear personal protective equipment. Using protection
glasses, anti-dust mask, protection mask, slip safety footwear,
long-sleeved clothing, gloves and helmet under proper
conditions, reduces the risk of injury.
The clothing worn while operating the machine must be
appropriate and tight, such as a work boiler suit. Do not wear
loose clothing or jewelry. Keep hair, clothing and gloves away
from the moving parts.
The control and safety devices installed in the machine must not
be removed or inhibited.
To avoid the risk of accidents, the following precautions must
be considered:
▪
The rotating accessories' rated speed shall be, at least, equal
to the maximum speed indicated in the technical
specifications of the power tool;
▪
When using the impact drill hammer, place yourself in a
stable position and well balanced. Hold the equipment firmly
with both hands to ensure a continuous operation and to
withstand unexpected situations, such as a backlash;
▪
The backlash is a sudden reaction that happens when the
power tool is switched on and the rotating accessory gets
stuck or is pressed. The backlash causes an instantly
reversing movement of the equipment;
27