Craftsman 247.77638 Manual Del Operador página 10

2. A. Align the chipper chute over the weld studs, so the slot in the
bottom of the chute is facing down. See Figure 6.
B. Secure chipper chute with the three cupped washers (cupped
side against the chipper chute) and hex nuts previously
removed. Do not tighten the nuts at this time.
3. The chipper shredder was shipped with one end of the support
brace already secured to the lower frame. Loosen but do not
remove the bolts securing the brace to the frame.
A. Align the holes in the chute with the holes in the top of the
brace and attach brace to chipper chute with hardware
previously removed. The flat washers should be placed under
the bolt heads and against the inside surface of the plastic
chipper chute. Tighten securely. See Figure 7.
B. Tighten the bolts securing the support brace to the frame.
C. Tighten the three nuts on the weld studs holding the chipper
chute to the impeller housing.
aTTacHing THE bag
1. To attach the bag:
A. Place the opening of the bag completely over the chute
deflector.
B. Pull on the drawstring until the bag is tight around chute
deflector opening.
C. Clip drawstring back on itself, tight against chute deflector to
secure into position. See Figure 8.
ASSEMBLY
B
10
A
Figure 6
A
Figure 7
C
B
A
Figure 8
B
C