A. Introduction
A.1 Working environment:
Temperature: 5 °C-40 °C
Humidity: ≦85%
Atmospheric pressure: 700-1060 hpa
Power source: AC 220V-240V; 50HZ or AC 400V; 50HZ
The sauna cabin must be 12.7mm (0.5 inches) away from the wall at the least.
B. Safety cautions
B.1 Attentions
It is prohibited to install the gate lock for sauna cabin.
The sauna cabin must be well ventilated.
There are two main ventilators of sauna room:
1.Two vents on roof and floor;
2.Three vents on roof, floor and side wall.
B.2 Safety precautions
DO NOT touch the steam stove with your fingers or any metal tool.
DO NOT touch the sauna lamp by hand.
DO NOT use the sauna cabin under any of the following circumstances:
1.Those with unhealed wound, eye disease or serious burn;
2.The aged, valetudinarian and especially patients. Pregnant women and babies are prohibited.
3.Patients with hyperthermalgesia, obesity, heart disease, hypertension, circulatory system disease or
diabetes must consult the doctor before using this product.
DO NOT bring pets into the sauna cabin.
DO NOT use this product after overdrinking.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
Cleaning and user maintenance shall not be made by children without supervision.
Children being supervised not to play with appliance.
The sauna room is to be inspected before restarting the timer.
Cleaning with steam cleaners, high pressure cleaners and spraying water is not allowed.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Caution: The appliance is non-self-resetting thermal cut-out.
WARNING: Do not cover.
The material of the sauna wall and sauna ceiling.
The sauna heater must be used alone.
Warning: before obtaining access to terminals, all supply circuits must be disconnected.
ENGLISH
11