Power Switch; Connecting To A Power Source - GYS E1 AUTO Manual De Instrucciones

User manual
E2
1- Gas connector (torch 1)
2- Gas connector (torch 2)
3- Reel support Ø 200 mm (torch 1)
4- Reel support Ø 200/300 mm (torch 2)
5- Cable support
6- Torch support
7- HMI
8- START/STOP switch
9- Ground clamp cable (3.5 m)
E3
1- Gas connector (torch 1)
2- Gas connector (torch 2)
3- Gas connector (torch 3)
4- Reel support Ø 200 mm (torch 1)
5- Reel support Ø 200 mm (torch 2)
6- Reel support Ø 200 mm (torch 3)
7- Cable support
8- Torch support
9- HMI
10- START/STOP switch
HUMAN-MACHINE INTERFACE (HMI)
Please read the Interface (HMI) manual which is part of the equipment's user literature.
HMI

POWER SWITCH

The material is supplied with a 16A plug type CEE7/7 and must only be used on a single-phase electrical installation 230V (50-60 Hz) with 3 wires
including one connected to earth.
The absorbed effective current (I1eff) is shown on the device for optimum operating conditions. Check that the power supply and its safeguards (fuse
and/or circuit breaker) are compatible with the electric current being used. In some countries, it may be necessary to change the plug to allow the use
at maximum settings.
• The power source is designed to operate on 230 V -20% +15%. The machine goes into protection mode if the supply voltage is below 185 Veff or
above 265 Veff. (an error code will appear on the display screen).
• The power is switched on by pressing the START/STOP switch (On), conversely switching off is done by pressing the same switch (Off). Warning!
Never disconnect the machine from the power supply while the machine is charging.

CONNECTING TO A POWER SOURCE

This equipment can be operated with electric generators provided that the auxiliary power supply meets the following requirements:
- The voltage must be alternating, and the RMS value must be 230 V -20% +15%, with peak voltage below 400V,
- The frequency must be between 50 and 60 Hz.
It is imperative to check these requirements, as many generators generate high voltage peaks that can damage these machines.
USING EXTENSION LEADS
All extension leads must be of a suitable length and width that is appropriate to the equipment's voltage. Use an extension lead that complies with
national safety regulations.
Input voltage
230 V
SETTING UP THE REEL
a b
22
Translation of the original
instructions
Extension lead cross section (<45m)
2.5 mm²
- Remove the nozzle (a) and contact tube (b) from your MIG/MAG torch.
10- Euro connector (torch 1)
11- Euro connector (torch 2)
12- Bulkhead connector for gas
13- Mains cable (6.25 m)
14- Bottle holder 4 m3 or 2 x 4 m3
15- USB hatch
16- Wire-feed motor (torch 1)
17- Wire-feed motor (torch 2)
11- Ground clamp cable (3.5 m)
12- Euro connector (torch 1)
13- Euro connector (torch 2)
14- Euro connector (torch 13
15- Bulkhead connector for gas
16- Mains cable (6.25 m)
17- Bottle holder 4 m3 or 2 x 4 m3
18- USB hatch
19- Wire-feed motor (torch 1)
20- Wire-feed motor (torch 2)
21- Wire-feed motor (torch 3)
E1 - E2 - E3 GYS AUTO