Normative Of Reference, Declaration Of Conformity Of The Builder 7. - Fiem SMART Manual De Uso

THE MANUFACTURER
THE MACHINE
MODEL
MATRICULATION
IS MANUFACTURED AND SOLD IN CONFORMITY TO THE ESSENTIAL
REQUIREMENTS OF HEALTH AND SAFETY D.M. 17 of 27 January 2010
Attachement I (implementation of the Machinery Directive 2006/42/EC)
The metallic plate
on the plate are reported all the datailed informations in the machine directory.
THE FOLLOWING ARMONIZED RELUS HAVE BEEN UTILIZED FOR THE CORRECT IMPLEMENTATION
OF THE ESSENTIAL REQUIREMENTS OF HEALTH AND SAFETY OF THE ATTACHED I
EN 55014-1:2006 + A1:2009 + A2:2011
EN 61000-3-3:2014
Guanzate
The Declarator
7 . B E F O R E T O C A L L F O R S E R V I C E A S S I S T A N C E
Before to call the technical assistance, it is suitable to check the followings failures more common and ope-
rate in conformity.
PROBLEM
The machine does not work.
Low working temperature
Thermometer with colored liquid
interrupted
Automatic egg-turner
device does not work
Insufficient ventilation
It is severely forbidden any attempt of reparation of the machine, which is not between those suitable in the
aboveshow table, contact always technical assistance at the factory to the tel. 0039 031 / 97 66 72 ISND
fax. 031 / 89 91 63 – www.fiem.it - e-mails: fiem@fiem.it o incubators@fiem.it.
16
DECLARATION OF CONFORMITY
To senses of the attachment I, D.Lgs. 17/2010/CE
F.I.E.M. S.r.l. Via G. Galilei, 3 - 22070 Guanzate (Como) - Italy
D E C L A R E S
Incubator
SMART
apposited on the machine is an integral part of the same;
EN 55014-2: 2015
EN 61000-3-3:2013
CAUSE
Lack of power
Disconnected plug
Any of above points
Heating element bad working
Uncalibrated thermostat
Not or bad working thermostat
Room temperature under 18°C
Impacts, accidental drop
Lack of power
Plug disconnected
Egg-turner motor broken
Fan Motor does not work
T H A T
SOLUTION
Check the plug
connect the plug
Contact the assistance service
Contact the builder
See the instruction for the calibration
Contact the builder
Place the incubator into a warm room
Try to expose the thermometer for few
minutes to low temperatures (freezer)
then in cold water otherwise substitute it
Check the plug
Put the plug into the socket
Contact the builder
Contact the builder