Troubleshooting Table - Snapper SC60V Manual De Instrucciones

WARNING:
recommended remedies below except remedies that require operation of the unit.
TROUBLE
Bar and chain
running hot and
smoking.
Motor runs, chain
is not rotating.
Motor runs, chain
rotates but does
not cut.
Chain saw stops
while cutting.
Chain saw does
not turn on.
TROUBLESHOUTING TABLE
Always stop unit and remove battery before performing all of the
CAUSES
Check chain tension for
overtightened condition.
Chain oil tank empty.
Chain tension too tight.
Check guide bar and chain
assembly.
Check guide bar and chain
for damage.
Dull chain.
Chain on backwards.
Chain saw is overloaded.
Battery is not charged.
Battery is not secure.
REMEDY
Loosen the chain if it is too tight. Refer to
Adjusting the Chain Tension earlier in this
manual.
Check oil tank.
Loosen the chain if it is too tight. Refer to
Adjusting the Chain Tension earlier in this
manual.
Refer to Replacing the Bar and Chain
assembly earlier in this manual.
Inspect guide bar and chain for damage.
Sharpen or replace the chain.
Reverse direction of chain.
Release the trigger to reset the internal
circuit breaker.
Do not force the chain saw.
Charge the battery. Refer to the battery
and charger manual for correct charging
procedures.
To secure the battery, make sure the
latches on the battery compartment snap
into place.
21