Installing The Bar And Chain - Snapper SC60V Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DANGER:
Never start the motor before installing the
guide bar, chain, chain cover, and chain
cover lock nuts. Without all these parts
in place, the clutch can fly off or explode,
exposing the user to ever start the motor
before installing the guide bar, chain, chain
cover, and chaincover lock possible serious
injury.
WARNING:
To avoid serious personal injury, read and
understand all the safety instructions in this
section.
WARNING:
Before performing any maintenance, make
sure the battery is removed. Failure to heed
this warning could result in serious personal
injury.
CAUTION:
Always wear gloves when handling the bar
and chain; these components are sharp and
may contain burrs.

INSTALLING THE BAR AND CHAIN

• Ensure that the battery has been removed
from the chainsaw
• Remove the wrench located in the rear of
the handle
• Remove the chain cover lock nuts from the
chain cover with the wrench by rotating them
counterclockwise.
Wrench
• Remove the chain cover from the chainsaw.
ASSEMBLY
Chain Cover
Chain cover
lock nuts
8
• Remove the plastic covering from the
bar and chain that was included with this
chainsaw.
NOTE: Make certain of chain direction.
Cutters Chain Rotation
Chain Drive Links
• Loop the chain around the sprocket.
• Place the bar and chain onto the mounting
surface so that the bar studs go through the
slot on the bar and the adjustment pin goes
through the adjustment pin hole.
NOTE: You may have to loosen the
adjustment pin with the wrench in order to
properly seat the bar on the chainsaw.
Sprocket
• Place the chain cover back on the chainsaw.
Bar Studs
Adjustment Pin

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido