Battery Removal; Important; Battery Installation - Snapper SC60V Manual De Instrucciones

• Re-install the chain cover lock nuts by hand
tightening them.
• Tighten the chain tensioning by rotating the
chain tensioning adjustment screw clockwise.
NOTE: Do not overtighten the chain.
• Fully tighten the chain cover lock nuts with
the wrench by turning the nuts clockwise..
Wrench

BATTERY INSTALLATION

1. Align the battery pack (3) with the battery
compartment on the chain saw.
2. Grasp the front handle (2) firmly.
3. Push the battery pack into the battery
compartment until the battery release button
(1) locks into place.
4. You should hear a "click" once the battery
is installed.
3
1
ASSEMBLY
Chain Cover
Chain cover lock nuts
2

BATTERY REMOVAL

1. Press the battery release button (1). This
will cause the battery to raise out of the tool
slightly.
2. Grasp the front handle (2) firmly. Pull the
battery pack out of the handle.
NOTE:
The battery pack fits snugly into the
handle to prevent accidental dislodging. It
may require a strong pull to remove.

IMPORTANT:

This Lithium-ion battery pack is equipped
with an internal circuit breaker which will
automatically shut off the power to the tool if
overloaded. If this occurs, release the trigger
to reset the internal circuit breaker.
ADDING BAR AND CHAIN LUBRICANT
Use Bar and Chain Lubricant. It is designed
for chains and chain oilers, and is formulated
to perform over a wide temperature range
with no dilution required.
NOTE: Chain saw comes from the factory
with no bar and chain oil added. Level should
also be checked after every 20 minutes of use
and refilled as needed.
• Remove oil cap.
• Carefully pour the bar and chain oil into the
tank.
• Wipe off excess oil.
• Check and fill the oil tank when quick view
oil indicator is below the MIN Line.
• Repeat as needed.
NOTE: Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain.
NOTE: It is normal for oil to seep from the
saw when not in use. To prevent seepage,
empty the oil tank after each use then run
for one minute. When storing the unit for a
long period of time (three months or longer)
be sure the chain is lightly lubricated; this will
prevent rust on the chain and bar sprocket.
WARNING:
resources, please recycle or dispose of oil
properly. Consult your local waste authority
for information regarding available recycling
and/disposal options.
Quick View Oil Indicator
9
To preserve natural