Publicidad
Idiomas disponibles
Idiomas disponibles
5.2
Operating the vacuum cleaner
1.
Insert the desired accessory into the tube suction opening or directly to the main
body.
2.
Press the power button to turn the appliance on.
3.
This appliance has low and high suction power. To regulate the suction power, press
the suction power button on the battery pack.
4.
After vacuuming is finished, press the power button again to turn the appliance off.
5.
Empty and clean the dust cup. Hang the appliance on its wall mounting bracket.
6. MAINTENANCE AND CLEANING
Note: Always switch off, and disconnect the appliance from the power supply (if charging)
before changing accessories, cleaning or maintenance.
1.
Do not submerge the appliance, its supply cord, and adapter in water or other liquids.
2.
Avoid corrosive liquids and materials. Do not use any abrasive cleaners, chemicals,
glass cleaners, universal cleaners, disinfecting agents or oil-based maintenance
agents! Those products may damage the appliance.
3.
Do not disassemble or modify the appliance. Changes or modifications will void the
user warranty.
4.
To protect the built-in battery, keep it in a dry place at a temperature of 0-40°C and
out of the reach of children and pets.
6.1
Cleaning the main body and accessories
1.
Use a soft damp cloth to wipe off any dirt from the main body. Pay attention to not
allow water to get inside the appliance. Let it dry completely before use.
2.
Wipe the accessories with a soft damp cloth and, if necessary, a little mild detergent.
Let them dry completely.
6.2
Cleaning the duct container
1.
Press the dust cup release button and lift it upwards to separate the dust cup from
the main body. Be careful not to press the power button.
2.
Gently pull the filter and its protection from the duct container under the dustbin.
Empty the contents of the dust cup into a dustbin and clean it with a damp cloth, with
a soft brush or rinse with cold water if necessary. Ensure the dust cup is completely
dry before replacing it.
3.
Remove the filter from the filter protection by turning it anti-clockwise and lifting it
upwards. Clean the filter with a dry cloth or a soft brush. Run cold water over the
outside of the filter and filter protection until the water runs clear, if necessary. Wash
the filter regularly or as required. Lay the filter, and filter protection on its side to dry
completely.
4.
When completely dry, reinstall the filter protection into the duct container first. Put
it in the filter protection and lock it into place by turning it clockwise. Make sure it is
fitted properly. Then, fit the filter into the filter protection.
13 13
EN
Publicidad
