STARLINK Pivot Mount Manual Del Usuario página 8

INSTALLATION
Instructions
Unplug your Starlink from wall before beginning the
installation process. Recommend installing the Pivot
Mount on an overhang.
1. Turn knob counterclockwise to loosen mount arm.
2. Orient arm to be perpendicular to base to help
with screw installation.
3. Find stud on roof using a stud finder.
4. Place mount over stud and mark two circles
on roof.
5. Drill pilot holes into the two marked circles.
6. Create two oversized balls from the sealing
tape squares and press over each hole,
overlapping the edges.
7. Set the two sealing tape strips over the two holes
where the Pivot Mount will sit.
8. Line the two holes on the mount over the two
pre-drilled holes. Point the embossed arrows to the
roof ridge (up the pitch). Drive lag bolts ~90% in.
9. Use socket wrench to tighten lag bolts to be snug
plus a quarter turn.
ENGLISH