Preparing For Maintenance; Replacing The Air Filter; Changing The Engine Oil - Toro Recycler 22in Manual Del Operador

Preparing for Maintenance

1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark plug wire from the spark plug
and hook it onto the retaining post (Figure 23)
before performing any maintenance procedure.
Figure 23
3. After performing the maintenance procedure(s),
connect the spark plug wire to the spark plug.
Important: Before tipping the mower to change
the oil or replace the blade, allow the fuel tank
to run dry through normal usage. If you must
tip the mower prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip
the mower onto its side, with the air filter up.
Tipping the mower may cause the fuel to leak.
Gasoline is flammable, explosive and can cause
personal injury.
Run the engine dry or remove the gasoline with
a hand pump; never siphon.
All manuals and user guides at all-guides.com

Replacing the Air Filter

Service Interval: Every 25 hours
1. Use a screw driver to open the air filter cover
2. Replace the air filter (Figure 25).
3. Install the cover.

Changing the Engine Oil

Service Interval: After the first 5 hours
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Refer to Preparing for Maintenance.
2. Remove the dipstick (Figure 26).
15
(Figure 24).
Figure 24
Figure 25
Yearly