Replacing The Fuse - Toro Recycler 22in Manual Del Operador

Figure 26
3. Tip the mower onto its side with the air filter up
to drain the used oil out through the oil fill tube
(Figure 27).
Figure 27
4. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 26). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE
30W detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.)
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
All manuals and user guides at all-guides.com
Charging the Battery
Service Interval: Every 25 hours
Electric-start models only
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger
in a sheltered area and charge the battery at room
temperature (70° or 22° C) whenever possible.
1. Connect the charger to the mower wire harness
2. Plug the charger into a wall outlet.

Replacing the Fuse

Electric-start models only
If the battery does not charge or the engine does not run
with the electric starter, the fuse may be blown. Replace
it with a 40-amp plug-in type fuse. Refer to Installing
the Fuse.
16
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
located below the ignition key (Figure 28).
Figure 28
Note: When the battery no longer holds a charge,
recycle or dispose of the lead-acid battery according
to local codes.