Optika Italy B-380 Serie Manual De Instrucciones página 31

6. Using the centering screws ③ on the side of the lamp
housing, center the image of the arc. (Fig. 45-46)
7. Using the focusing screw of the collector lens
image until a homogeneous illumination is achieved (Fig.
47). At this point, insert an objective into the optical path and,
looking into the eyepieces, optimize the illumination always
using the screws ②
8. After replacing the exhausted bulb, reset the time counter on
the power supply by pressing the "Reset" button
and ③.
②
enlarge the
① (Fig. 48)
Page 31
F ig. 46 F ig. 46
F ig. 47 F ig. 47
①
F ig. 48 F ig. 48