Publicidad
Idiomas disponibles
Idiomas disponibles
2 . 1
U N P AC K I N G .
After delivery, immediately unpack the open front cooler, check it hasn't suffered any
-
damage caused by transportation. Please look for dents, scratches, etc. and make sure it
works. All safety devices must be present and functional before operating the unit.
Report any damage to local sales partner immediately. For the rest, Efficold's terms and
-
conditions apply.
Check that the open front cooler has been transported following the position indicated on the
-
packaging. If the open front cooler has not been transported in the recommended position,
please place it in the correct position and wait at least 24 hours before starting it up, in order
to prevent any damage. The open front cooler may only be operated in its upwards position,
standing on the rollers, (Please, observe the installation instruction).
When unpacking the open front cooler, be careful not to damage the product.
-
After unpacking the
-
MAINTENANCE).
Recyclable elements are marked.
-
ATTENTION: To prevent the open front cooler from being damaged, it may only be transported
and stored when in its usage position. Non-observance of this requirement will result in a loss of
warranty.
2 . 2
L O C AT I O N .
Put the open front cooler in a well-ventilated place, away from heat sources, minimal 70 mm from
any neighbouring surfaces (e.g. walls).
Avoid draughts and major thermal irradiation at the installation site. Therefore, do not put the
open front cooler in front of radiators, heaters or under air vents. The smooth operation of the
open front cooler can be compromised by the influence of continuous air movement (fans, air
conditioning, etc). Also, any heat that is incident on the open front cooler will lead to increased
operating costs and may have an adverse effect on its performance.
Do not point spotlights at the open front cooler.
Air circulation around the open front cooler must not be impeded. The open front cooler air inlets
and outlets must not be.
Apply brakes to the roller braking mechanism (see the following pictures):
Picture 1a: apply brake
2
I N S T A L L A T I O N .
open front
cooler, it must be cleaned (section GENERAL
Picture 1b: release brake
5
Publicidad
