Motorola MDHTN3001 Guia Del Usuario página 9

b. pressing the battery toward the rear of the pocket
c. sliding the battery into the charger pocket, ensuring
complete contact between the charger and battery contacts
4. When the battery is properly seated in the pocket, the charger
LED will change to a steady red to indicate that the battery is
charging rapidly. When the battery is 90% charged, the LED will
begin to blink green to indicate that the battery is trickle
charging. When the battery is fully charged, the LED will
change to a steady green light to indicate that the battery is fully
charged.
Note: Even though new batteries might prematurely indicate a
full charge (steady green LED), charge the battery for 14 to
16 hours prior to initial use for best performance. Batteries
will charge best at room temperature.
Troubleshooting
When troubleshooting, always observe the colour of the LED:
Table 4: LED Indications of Battery/Charger Status
LED Colour
No LED indication Battery is inserted incorrectly.
Single green blink
Blinking red
Steady red
Blinking yellow
Blinking green
Steady green
No LED Indication?
1. Check that the radio with battery, or the battery alone, is
inserted correctly (refer to step 3 on page 7).
Battery/Charger Status
Successful charger power-up
Battery is unchargeable or not making proper contact.
Battery is in rapid-charge mode.
Battery is in charger, not in rapid-charge mode but
waiting to be charged.
Battery is charged (to 90% or greater capacity).
Battery is fully charged.
7