Install Range Hood; Electrical Connection - arietta ATS436SSB Guía De Instrucciones Para Instalación

Install Range Hood

Remove all packaging materials and protective film from hood.
Using 2 or more people, hang range hood on 2 mounting screws
through the mounting slots on back of hood.
B
C
1. Mark with a pencil the lower mounting holes location.
2. Uninstall the hood assembly, and drill 3⁄16" (4.8 mm) pilot
holes at marked locations.
3. Hang the range hood again on 2 upper mounting screws.
4. Level the range hood and tighten upper mounting screws.
5. Install 2 - 5 x 45 mm lower mounting screws and tighten. Use
the optional wall anchors if needed.
6. Remove plastic bag with styrofoam located behind the blower
motor from inside the hood.

Electrical Connection

I
WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR ELECTRICAL
SHOCK.
1. Disconnect power.
2. Remove terminal box cover.
3. Remove the knockout in the terminal box cover and install a
UL listed or CSA approved 1⁄
A. Terminal box
B. Knockout
C. Terminal box cover
A
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
" strain relief.
2
B
C
A
For vented installations only:
1. Fit vent system over the exhaust outlet.
2. Measure from the bottom of the air deflector to the bottom of
the hood outlet. Cut the ductwork at the measured dimension.
Wall
outlet
4. Seal connection with clamps.
5. Check that back draft dampers work properly.
4. Run home power supply cable through strain relief, into
terminal box.
G
A. Home power supply cable
B. UL listed or CSA approved strain relief
C. UL listed wire connectors
D. White wires
5. Use UL listed wire connectors and connect black wires (C)
together.
6. Use UL listed wire connectors and connect white wires (E)
together.
7
Roof outlet
Dimension
to measure
A
B
C
D
E
F
E. Black wires
F. Green (or bare) and yellow-
green ground wires
G. Terminal box