Troubleshooting - PRACTIXX PX-KZS-305PA Traducción Del Manual De Instrucciones Original

15. Troubleshooting

Fault
Motor does not work
The engine runs slowly and
does not reach the operating
speed.
Engine producing excessive
noise.
The engine does not reach full
power.
Motor overheats easily.
Saw cut is rough or wavy.
Workpiece pulls away and/or
splinters.
40 | GB
Possible cause
Engine, cable or connector defective,
mains fuses blown.
Voltage too low, coils damaged, capacitor
burnt.
Coils damaged, motor defective.
Circuits in the network are overloaded
(lamps, other motors, etc.).
Overloading of the motor, insufficient
cooling of the motor.
Saw blade dull, tooth shape not
appropriate for the material thickness.
Excessive cutting pressure and/or saw
blade not suitable for use.
www.practixx.com
Remedy
Arrange for inspection of the machine
by a specialist.
Never repair the motor yourself.
Danger!
Check mains fuses and replace as
necessary
Have an electrician check the voltage.
Arrange for inspection of the motor by
a specialist. Arrange for replacement
of the capacitor by a specialist.
Arrange for inspection of the motor by
a specialist.
Do not use any other equipment or
engines on the same circuit.
Avoid overloading the motor while
cutting, remove dust from the motor
in order to ensure optimal cooling of
the motor.
Resharpen saw blade and/or use
suitable saw blade.
Insert suitable saw blade.