Design; Assembly - GOK Caramatic ProTwo Instrucciones De Montaje Y Funcionamiento

DESIGN

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage
during transport. ASSEMBLY must be carried out by a specialised company.
See USER QUALIFICATION!
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
Consider installation location and installation position (see instructions on INTENDED USE).
Risk of injuries due to blown-out metal chips!
Metal chips may cause eye injuries.
Wear safety goggles!
Malfunctions caused by residues! Proper functioning is not guaranteed.
Visually check that there are no metal chips or other residues in the connections!
It is important that metal chips or other residues are blown out!
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection
nozzle.
Do not use unsuitable tools, such as pliers.
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
Observe the installation direction (marked on the product with an arrow
18 / 145
Nose indicating the withdrawal
direction on the rotary knob
Rotary knob for the operation of
reserve cylinder
Inlet connections
Outlet connection
Assembly board (elbow)
Sealing nut with strap on
inlet connection
Operation and spare cylinder display
(green/red) visual indicator type AUV
Breather for the PRV
Test connector with screw cap
Check valve with twist grip
Connection for Eis-Ex regulator
heating
Screw aid SW 23
Caramatic ProTwo
).
Artikel-Nr. 71 923 50