Publicidad
14 Change parameters in Setup
ü The basket or insert has been removed.
ü If using temperatures > 50 °C, allow the cleaning fluid to cool.
1. Disconnect the network cable.
2. Put the cover on.
3. Firmly take hold of the unit by the handles while holding the cover in place, and carry it carefully to
a sink.
4. Remove the cover.
5. Slowly tip the unit over the sink with one corner at the lowest point, and carefully pour out the
cleaning fluid.
ðThe tank has been drained.
6. Clean and, if necessary, disinfect the tank. See chapter Maintenance for more information.
CAUTION! Never submerge the unit in water.
è The unit has been drained, cleaned and, where necessary, disinfected.
14
Change parameters in Setup
The unit is connected to a power supply.
The Parameter reference list is required for setting the parameter numbers and values.
The unit is switched off.
Hold down the Mode button until the Setup menu is shown on the display.
First, press the Plus/minus buttons to set the parameter number, e.g., 01.
Then, press the Plus/minus buttons to change the parameter value, e.g., 00/01.
Set and change further parameters as required.
Press the On/off button to save the settings.
Parameter reference:
The following unit functions can be adjusted. The preset factory values are shown in bold:
Parameter
Unit function
Adjustment range for
01
cleaning duration > 10 min.
Show remaining time
02
< 1 min. in seconds
03
Temperature unit
24 / 28
Value
00/01
00/01
°C/°F
Effect
Increments of 5 min./increments
of 1 min. (as for cleaning durations
up to 10 min.)
Off/on
Display in degrees Celsius/
Fahrenheit.
Renfert
Easyclean MD
Publicidad
