Publicidad
Renfert
Default temperature limit
04 **
(can be used in Normal
mode)
Acoustic signal for "End of
05
cleaning"
Acoustic signal for "Error
06
message"
Acoustic signal for "Tem-
07
perature limit exceeded"
Response if temperature
08
limit is exceeded
09
Display brightness
10
LED test
Autostart on restoration of
20 *
power supply
30
Reset unit settings
Response if dry-run pro-
31
tection is triggered
* The unit starts up immediately in heating and/or ultrasound mode when plugged in or when the
power supply is switched on.
** Can be used in Normal mode; in Programme mode the temperature limit is always 55 °C/130 °F.
15
Malfunctions/error messages
15.1 Troubleshooting
Fault
Display does not light up.
Buttons not working.
Not possible to set a
high bath temperature.
Easyclean MD
00/40/45/50/55/60
00/100/110/120/13
0/140
00/01/02
00/01/02
00/01/02
00/01/02/03
01/02/03/04
00/01
00/11/12/13
00/11
00/01
Possible cause
Unit not switched on or
no power available.
Controls defective.
A low temperature limit
has been defined.
Off/40 °C/45 °C/50 °C/55 °C/
60 °C
Off/100 °F/110 °F/120 °F/130 °F/
140 °F
Off/melody 1/melody 2
Off/melody 1/melody 2
Off/melody 1/melody 2
No action/ultrasound off/heating
off/ultrasound and heating off
Dim/medium/normal/bright
Off/all display LEDs on for ap-
prox. 5 s
Off/ultrasound on/heating on/ul-
trasound and heating on
CAUTION! Risk of damage
to the unit if the unit runs dry.
Off/on: "11" resets all settings to
the factory settings.
No action/ultrasound and
heating off, display Dry run
symbol.
Resolution
• Switch on the unit.
• Check that the power cable is correctly
connected and undamaged; replace if ne-
cessary.
• Check the power supply.
• Contact the manufacturer.
• Check the unit settings; increase or deac-
tivate the temperature limit as required.
15 Malfunctions/error messages
25 / 28
Publicidad
