Publicidad
Idiomas disponibles
Idiomas disponibles
Control panel
Figure 3: Display
Automatic mode
Display
Continuous
operation
Display:
The illuminated display shows the prevailing room humidity as soon as the unit is plugged in.
During the setting of the timer and the target air humidity, the selected values are displayed.
Once the setting has been completed, the current room humidity is displayed again.
Installation instructions
Operate the device only in rooms with at least 6m² of floor space.
base
•
Remove all adhesive tapes that have been used to secure the unit during transport.
•
Check that the unit stands securely on a firm, level and dry surface.
•
Never install the unit where it may be exposed to the following conditions:
Heat sources such as radiators, heat registers, stoves or other products that
o
generate heat.
In an area where oil or water can be sprayed.
o
Direct sunlight
o
Mechanical vibration or shock
o
Excessive dust exposure
o
Lack of ventilation, e.g. in cupboards or bookshelves
o
Uneven surface
o
•
Make sure that the outlet is equipped with an RCD circuit breaker. If you are not sure whe-
ther this is the case, you can ask your electrician or use a personal protection
plug (available in the DIY store).
•
To save power and avoid potential hazards, disconnect the unit when not in use.
EN-8
Timer
Fan speed
Blue: Small fan stage
Orange: Large fan stage
Tank "full" Power indicator
www.comedes.com
Publicidad
