Maintenance - Victor STATE VWRP-3800 Manual De Operación

Always keep the turntable clean. If the surface of the unit gets dirty, wipe with a soft dry cloth or use
a diluted mild liquid soap. Be sure to remove any excess liquid completely. Do not use thinner,
benzine or alcohol as they may damage the surface of the unit. Allow the surface of the unit to dry
completely before using.
Beware of condensation
When the unit (or a record/disc) is moved from a cold to warm place, or used after a sudden
temperature change, condensation may form; vapor in the air could condense on the internal
mechanism, making correct operation erratic or impossible. To prevent this, or if this occurs, leave
the unit turned off for one or two hours. The unit will stabilize at the temperature of its surroundings.
Using Compact Discs
Discs which can be played on this unit:
● Conventional audio CD
● Properly finalized CD-R and CD-RW discs
● Always place the disc on the disc tray with the label side up. (Compact discs can be played or
recorded only on one side.)
● To remove a disc from its storage case, press down on the center of the case and lift the disc
out, holding it carefully by the edges. Should the disc become dirty, wipe the surface radially
(from the center hole outward towards the outer edge) with a soft, dry cloth.
● Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to
clean the discs. Such chemicals will do irreparable damage to the disc's plastic surface.
● Discs should be returned to their cases after use to avoid dust and scratches that could cause
the laser pickup to "skip."
● Do not expose discs to direct sunlight or high humidity and temperature for extended periods.
Long exposure to high temperatures will warp the disc.
Do not play any disc that is warped, deformed or damaged. Playing such discs may cause
●
irreparable harm to the playing mechanisms.
● CD-R and CD-RW discs are more sensitive to the effects of heat and ultraviolet rays than
ordinary CDs. It is important that they are not stored in a location where direct sunlight will fall
on them, and away from sources of heat such as radiators or heat-generating electrical
devices.
● Printable CD-R and CD-RW discs are not recommended, as the label side might be sticky
and damage the unit.
● Do not stick papers or protective sheets on the discs and do not use any protective coating
spray.
● Use a soft oil-based felt-tipped pen to write the information on the label side. Never use a
ball-point or hard-tipped pen, as this may cause damage to the recorded side.
● Never use a stabilizer. Using commercially available CD stabilizers with this unit will damage
the mechanisms and cause them to malfunction.
● Do not use CDs with an irregular shape (octagonal, heart shaped, business card size, etc.).
CDs of this sort can damage the unit:
● If you are in any doubt as to the care and handling of a CD-R/CD-RW disc, read the
precautions supplied with the disc, or contact the disc manufacturer directly.

MAINTENANCE

14