Bulb Replacement; Important - Infiniton CMPTRAL-BL94 Manual De Instrucciones

Maintenance and cleaning
Carbon filter - not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be
changed eyery 3 to 6 months according to your cooking habits. The installation procedure of activated
carbon filter is as below:
1. Before installing or replacing the carbon filters, disconnect the
mains power to the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both sides of the motor anti-clockwise.
Replace thecarbon filters with the new carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
Note: Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
When activated carbon filter attached, the suction power will be lowered.

Bulb replacement

IMPORTANT!

Note: Before changing the lights, make sure that the appliance isturned off and unplugged.
Protect against danger when changing lights, such as wearing gloves.
To change the cooker hood lights, follow the steps below:
Remove the grease filter.
Use a tool or the hand to press the spring splinter of both sides of LED light to the inside, until the light is
pressed out.Then slightly pull the light connecting wire out and replace the lights.
Apply the reverse procedure to install the light back.
ILCOS D code for this lamp is: DSR-1.5/65-S-64
– LED modules– round lamp
– Max wattage: 2×1.5 W
– Voltage range: DC 12V
– Dimensions:
The bulb must be replaced by the manufacturer, its service agent or
similarly qualified persons.
Always switch off the electricity supply before carrying out any operations
on the appliance. When handling bulb, make sure it has completely cooled
down before any direct contact with hands.
When handling bulbs hold with a cloth or gloves toensure perspiration does
not come in contact with the bulb as this can reduce the life of the bulb.
12
English