Sunbeam Products Oster OS-WSMD16S Manual De Instrucciones página 25

b.
According to the diagram, the water inlet is aligned with the tap and the nut
on the water inlet is tightened.
Connection between water inlet and Washing machine
2)
a. Before connecting, please check whether the
sealing gasket in the water inlet nut has fallen
off or not.
b. Put water inlet nut on inlet valve joint.
c. Tighten the water inlet nut.
4 Connection of the drain hose (some modes have been connected)
a. P ress down the fix ring,
and hitch it over the drain hose.
5 To change the side of drain hole on body
a. Remove the
cover from
left side.
c. Loosen the fixing ring on pipe,
turn the drain hose to left side
Left side view
hole of body,then reinstall the fixing ring.
Pls note to put the sealing ring back, in
case leaking water issue.
sealing gasket
b. Press down the fix ring, and
then connect the drain hose with
the connection pipe.
d.Move the connection
b. Remove the two
part of drain hose to
pieces of screw
left side and fix it,
of right side hole.
using the two pieces
screw.
right side view
Left side view
English-7
sealing gasket
inlet valve joint
c.Put the hose to drain hole, the hole
must be no higher than 90cm(A) from
bottom of machine.
fixing ring
Sealing ring
conncetion pipe of drainage
drain connection part
inlet valve nut
e.Use the cover to
seal the hole of
left side.
right side view