Hansgrohe Pharo SideWay 26310000 Manual Del Usuario página 14

uSED SyMBOLS/ TEChNICaL DaTa/ NOTE
Fitting items
Tools/ Montage
Dimensions Diagramm
hnical Data
Tec
Caution Water!
Before drilling the bottom hole pay
attention if water supply pipes cross
this area.
Minimum flow pressure
Operating pressure
Recommended operating pressure
Test pressure
(1 MPa = 10 bar = 147 PSI
Hot water temperature
Safety stop
Flow capacity at 3 bar
Handshower
Body showers 2 Stück
Body showers 3 Stück
Body showers 5 Stück
Hand- + Bodyshowers
Dimensions
The installation dimensions stated in this installation instruc-
tions are ideal for people of approximately 1800 mm in body
height.The dimensions can be altered if required. In this case
you will have to attend to the minimum height of 2150 mm from
shower tray floor, and alter all the required measurements as
necessary.
If the height of water connection are outside of the illustrated
range, the drill measurements must be adjusted accordingly.
(attention for minimum room height of 2150 mm from tub-floor).
Flush through the supply pipes(DIN EN 1717).
6
1.
0,2 MPa Operation, spare parts and flow capacity diagramm see on
page 2 + 3.
0,2- 0,6 MPa
Spare part numbers with XXX identification must be replaced
0,25- 0,5 MPa
by the code number relating to the finish of the product.
1,6 MPa
000
• identification in flow diagram: From • the function is guaran-
teed.
max. 70° C
38° C
Operation and function from handshower see on
enclosed brochure.
11,6 l/min
6,3 l/min
9,2 l/min
14,5 l/min
21,1 l/min
Note
Informs the personnel concerned of
information with important contents to
be observed.
Water connection DN 15
hot water 1/2"
Water connection DN 15
cold water 1/2"
Montage
chrom
use only free from acetic acid
Flow heater
Applicable for flow heaters at min. 24 kW and 2 bar
flow pressure before the Shower panel. Only one
function is possible, not two simultanously.
Pressure differences
The pressures of the cold and hot water connections
must be balanced.
Maintenance
The non return valves must be checked once a year
(DIN EN 1717).