Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING & MAINTENANCE
CLEANING THE PRE-FILTER
NOTE: For best performance,
vacuum the pre-filter once a
month under normal usage.
1. Unplug the air purifier.
2. Remove the True HEPA filter
as described in the Replacing
the True HEPA Filter section.
3. Vacuum the outside of the
True HEPA filter using the brush attachment of your vacuum
cleaner, cleaning it thoroughly.
4. Place the True HEPA filter back into the air purifier and close
grille.
5. Plug the power cord into a standard AC outlet.
TO CLEAN THE OIL TRAY
Open the oil tray and remove the
pad. Essential oil pads should be
changed when switching to a
different essential oil scent. If
continuing to use the same scent,
set the essential oil pad aside for
reuse. Wipe down the inside of
the oil tray with a soft cloth. Place the essential oil pad back in the
tray and close.
NOTE: Leave the essential oil pad out of the oil tray when storing.
TROUBLESHOOTING
PROBLEM
Unit will not operate
Reduced airflow
Reduced odour removal
Excessive noise
Replace filter light remains
lit after filter replacement
Display lights are off
Buttons do not operate
Remote control does not
operate
POSSIBLE CAUSE
• Unit is not plugged in
• Power button not pressed
• No power to unit
• True HEPA filter is not installed correctly
• Grille cover is not installed correctly
• The back grille may be blocked
• Pre-filter needs vacuuming
• The True HEPA filter needs to be replaced
• The True HEPA filter needs to be replaced
• The unit is not level
• The replace filter indicator needs to be reset
• Night indicator setting
• Child lock engaged
• Battery needs replacement
FOR BEST PERFORMANCE
• NEVER use water or any household cleaners or detergents to
clean the True HEPA filter.
• Clean off the outside of the unit with a dry cloth as needed.
• NEVER use water, wax, polish, or any chemical solution to clean
the outside of the unit.
• Clean off the grille cover using a damp cloth or the brush
attachment of your vacuum as needed.
• Vacuum the pre-filter monthly under normal usage conditions.
• Replace the True HEPA filter every 12 months under normal
usage conditions.
• Always use a genuine HoMedics replacement filter for optimal
performance.
To purchase genuine HoMedics replacement/spare parts please
visit www.homedics.co.uk
3 Pack of aroma pads - ARM-PAD3
Aroma tray (white) - AP-T40WTARM
Aroma tray (black) - AP-T40BKARM
HEPA filter - AP-T40FL
UV-C Bulb – AP-UVC1
Cover & screws - APUVCCV
• Plug unit in
• Press the power button to turn the power on
• Check fuses, try a different outlet
• Reinstall the True HEPA filter
• Reinstall the grille cover
• Check to make sure nothing is blocking the back
grille and air outlet
• Vacuum the pre-filter with the brush attachment
of your vacuum cleaner
• Replace the True HEPA filter
• Replace the True HEPA filter
• Place the unit on a flat, level surface
• Press and hold the ioniser button for 3 seconds
until the replace filter light turns off
• Press the night indicator button until the desired
lights are on/off
• Press and hold the night indicator and timer
buttons for 3 seconds to disengage the child lock
• Replace battery as shown in the remote control
battery replacement instructions
GB
I
7
SOLUTION
Publicidad
