Publicidad
Idiomas disponibles
Idiomas disponibles
PACKAGE CONTENTS
C
A
B
HARDWARE CONTENTS (not shown actual size)
AA
x 1
Touch-up Pen
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble or install the product.
WARNING
Do not stand on vanity. Use vanity on level ground. Base vanity supports a maximum weight of 200 lbs. Exceeding maximum
weight limit will compromise the integrity of the vanity structure and could cause the vanity to fail.
CAUTION
Do not hang from the vanity.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 15 minutes
Tools Required (not included): Silicone compound.
PART
DESCRIPTION
A
Vanity Top (preassembled)
B
Vanity Base
C
Backsplash
2
ASSEMBLY INSTRUCTIONS
Step 1: Vanity Drawer Removal
QUANTITY
Removing the Drawer:
1
1a. Unload the contents from the drawer.
1
1b. Slide out the drawer as far as it will go.
1
1c. Press the lever down on the right-hand track and lift the lever up on the left
track to release the drawer. Pull the drawer out the rest of the way.
Replacing the Drawer:
1d. Align the drawer guides with the receiving glides.
1e. Hold the receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time after it has been
removed. If the drawer does not go in smoothly, please take it out and
repeat the step.
1f. Push the drawer in completely.
Step 2: Adjustable Level
2a. In case of uneven floors, floor levelers are provided at the bottom of the
vanity. If necessary, adjust floor levelers by hand to correct tilting and/or
level doors.
Step 3: Backsplash Installation
3a. To mount the backsplash (C) to the wall, apply a thin bead of silicone
compound (not included) to the unpolished back side and bottom of the
backsplash (C). Position backsplash (C) as shown onto vanity top (A)
and against the wall. Clean any excess silicone compound before allow-
ing to dry.
1
2
3
C
A
3
Silicone
Publicidad
