Fanimation LP3071 Serie Manual De Instrucciones página 12

NOTE: If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by
a licensed electrician.
GROUND
AC POWER
3. Connect green wires from hanger bracket, hanger ball and ground from supply using wire connector. Connect
black wire from receiver unit marked "AC IN L" to black supply wire using wire connector. Connect white wire from
receiver unit marked "AC IN N" to white supply wire using wire connector. Connect white wire from receiver unit
marked "TO MOTOR N" to white wire from fan using wire connector supplied with receiver unit. Connect black
wire from receiver unit marked "TO MOTOR L" to black wire from fan using wire connector supplied with receiver
unit. Securely enclose the red supply wire with wire connector. (Figure 4)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
4. After connections have been made, the wires
should be spread apart with the grounded conductor
and the equipment-grounding conductor on one side
of the outlet box and the ungrounded conductor on
the other side of outlet box, then turn leads upward
and carefully push leads into the outlet box, with the
white and green leads to one side of the box and the
black leads to the other side. (Figure 5)
How to Wire Your Ceiling Fan (continued)
GREEN
BLACK
L
WHITE
N
RED
L1
RF ANTENNA
WARNING
HANGER
BRACKET
HANGER
BALL
BLACK BLACK
WHITE
WHITE
Figure 4
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
12
BLACK
WHITE
HARDWARE USED:
Wire
Connectors
White Wire
from Supply
White Wire
from Receiver
Receiver
Figure 5
x 6
Listed
Outlet Box
Household
Supply
Red Wire
from Supply
Black Wire
from Supply
Black Wire
from Receiver