Speed Control; Mode Of Operation - EINHELL VENTURRO 36/240 Manual De Instrucciones

6. Operation
Danger!
Start up the equipment only when fully assem-
bled.
6.1 Sizing the strap
Slip the harness over your shoulder and adjust
the length of the harness so that you can handle
the equipment comfortably.
Caution: Wear the harness in such a way that
the snap fastener is always close to hand. In
an emergency you can always remove the
equipment quickly by opening the snap fas-
tener (Fig. 12 / Item 5b).
6.2 Switching the machine On/Off (Fig. 13)
•
To switch on, press the On/Off switch (Item 1).
•
To switch off, let go of the On/Off switch.

6.3 Speed control

The equipment comes with a 5-step electronic
speed control system for setting the velocity of
the air current.
The display (Fig. 13 / Item 2a) shows the corres-
ponding number and color of bars.
1 green bar = lowest air velocity
4 green bars = highest air velocity in SPEED
mode
4 green bars + 1 red bar = highest air velocity in
BOOST mode
Use the equipment only with the air velocity nee-
ded for the job.
6.3.1 SPEED mode
•
You can change the air velocity in 4 steps by
pressing the SPEED button (Fig. 13 / Item
2b).
•
If you press the SPEED button (Fig. 13 / Item
2b) again when the highest air velocity is
active, the equipment will return to the lowest
level.
6.3.2 BOOST mode
•
If you need a higher air velocity, press the
BOOST button (Fig. 13 / Item 2c). The maxi-
mum air velocity will then be available. All the
bars will appear in the display (Fig. 13 / Item
2a).
Anl_Venturro_36_240_SPK13.indb 23 Anl_Venturro_36_240_SPK13.indb 23
GB
•
Press the BOOST button again to return to
SPEED mode.
Important: To minimize noise and maximi-
ze battery operating time, do not work in
BOOST mode any longer than necessary.

6.4 Mode of operation

Caution! Search the surface for concealed ob-
jects (e.g. small animals or hard foreign bodies)
before starting to use the equipment.
6.4.1 Blowing foliage
Caution!
If you point the air fl ow towards other people, ani-
mals or objects (e.g. windows), this could cause
injuries and damage.
•
Point the air flow away from yourself.
•
Never point the air flow towards other people,
animals or objects.
•
Do not blow away any hard objects such as
stones or twigs.
•
Turn the selector lever (Fig. 14 / Item 13) into
the position shown. You can do this regard-
less of whether the tool is running or not.
•
Channel the air stream forward and walk
slowly to blow foliage or garden refuse into a
pile or to clear out hard-to-reach places.
Danger!
Never gather (blow) hot, combustible or explosive
materials into piles.
6.4.2 Sucking up foliage
Caution!
•
Only use the leaf blower vac in vacuum mode
if the catch bag is undamaged and properly
fitted.
•
Do not pick up too many leaves in one go as
this could clog the tube and the shredder.
•
To clear any blockages, follow the steps de-
scribed in the section "Clearing blockages".
•
Do not pick up hard or damp materials.
•
Turn the selector lever (Fig. 14 / Item 13) to
position "B". You can do this regardless of
whether the tool is running or not.
•
Always position the suction tube on the
ground and adjust the length of the strap to
your requirements (see section 6.1). The gui-
de rollers (Fig. 1/Item 9) at the bottom end of
the suction tube will help you to maneuver the
suction tube on the ground.
- 23 -
05.04.2022 15:14:27 05.04.2022 15:14:27