Problem Solution - VATTON 48036 Manual De Instrucciones

EN
12. Make sure you have a secure footing before starting
the operation.
13. Hold the tool firmly when using it.
14. Do not operate the tool without load unnecessarily.
15. Immediately stop the engine and remove the battery
packs if the mower meets a fence or other hard object.
Check the cutter for damage, and if damaged, repair im-
mediately.
16. Before checking cutter, repairing faults, or removing
material trapped in cutter, always turn cutter off and re-
move battery packs.
17. Turn off the trimmer and remove the battery packs be-
fore performing any maintenance work.
18. When moving the hedge trimmer to another location,
even during work, always remove the battery packs and
attach the blade cover to the cutter blades. Never transport
or transport the trimmer with the trimmer running. Never
hold the cutter with your hands.
19. Clean the hedge trimmer and especially the trimmer
after use and before storing it for long periods. Lightly etch
the cutter and attach the cap.
20. Store the hedge trimmer with the cover on in a dry
place. Keep out of children reach. Never store the trimmer
outdoors.
WARNING!
Use of this product can create dust containing
chemicals that can cause respiratory or other
problems diseases. Some examples of these chemicals
are compounds found in pesticides, insecticides, fertilizers,
and herbicides. Your risk from these exposures varies, de-
pending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a
well-ventilated area and work with approved safety equip-
ment, like those dust masks that are specially designed to
filter out microscopic particles.

PROBLEM SOLUTION

1. I CANNOT FIT THE BATTERY INTO
THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot.
2. REASONS FOR DIFFERENT BATTER PACK
WORKING TIMES.
Charging time issues, as above, and having not used a
battery pack for a porlonged time will reduce the wor-
king life of the battery pack. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such as
large screws into than lighter working conditions. Do not
re-charge your battery pack below 0ºand above 50º as this
will affect performance.
3. HOT BATTERY PACK PROTECTION.
The normal charging temperature is between 0º and
50º. When the battery pack is too hot, it automatically starts
a HOT battery pack delay, and suspends charging until it
has reached the correct temperature. The charging process
will then automatically begin.
4. BATTERY PACK OVERLOAD AND
LOW-VOLTAGE PROTECTION.
When max. allowable battery current is exceeded during
working, the overload protection is activated to protect
the battery against overheating.When the battery is under
normal voltage during working, the power tool will cease
to operate.
MAINTENANCE
CAUTION:
- Always make sure the tool is turned off and the batteries
removed before attempting inspection or maintenance.
- Never use gasoline, benzene, thinner, alcohol or the like. It
can result in discoloration, warping or cracking.
CLEAN THE TOOL
Clean the tool by wiping away dust with a dry or soap-
soaked cloth.
BLADE MAINTENANCE
Coat the blade before and once an hour during operation
with machine oil or similar.
NOTE:
- After operation, remove the dust from both sides of the
blade with a wire brush, wipe it clean, and then apply enou-
gh low-viscosity oil, such as machine oil, etc. and lubrica-
ting oil spray.
CAUTION:
- Do not wash the blades with water. Failure to do so may
cause rust or damage to the tool.
6