EN
ON/OFF: When the unit is used for the first time, after an LR03 (AAA) battery is
inserted in the remote control, '10:00' and 'MON' light up on the screen.
Press the ON/OFF button on the remote control once to switch on the appliance
and the flame effect. 'H0' is displayed on the LED screen.
Heating: Press the HEAT button to activate the heating function. Pressing the
button once activates the low heating setting (900 W). 'H1' is displayed on the
LED screen. If you press the button twice, the high heating setting (1800 W) is
activated. 'H2' is displayed on the screen. Pressing the button again will disable the
heating setting.
Temperature: When you press the TEMPERATURE button, the temperature initially
shows 18 °C. Press the left + button to raise the temperature. Press the - button to
lower the temperature. There are 12 different temperature settings from 18 °C - 30
°C.
If you press the TEMPERATURE button again, the temperature setting is reset to
the original heating function: for example, if the setting was previously H0, it will
be reset to H0.
Press and hold the TEMPERATURE button for about 3 seconds to change from
degrees Celsius (°C) to degrees Fahrenheit (°C).
Flame: Press the FLAME button for the dimmer mode. Each time the button is
pressed, the flame intensity decreases. The device has 5 brightness levels that are
cycled through each time the button is pressed (F5, F4, F3, F2, F1). The LED screen
does not show this. This is shown on the unit.
Timer: Press the Timer button.
When you press the TIMER button for the first time, 'MON' flashes on the digital
screen. Use the UP and DOWN buttons to set the timer for the days of the week
Monday through Sunday.
Settings: When you press the SETTINGS button, 'HOUR' will flash on the digital
screen.
Use the UP and DOWN buttons to set the hours between 00:00 and 24:00. Press
the SETTINGS button a second time to set the minutes. The minute display flashes
on the digital screen.
Use the UP and DOWN buttons to set 00:00-12: 00 AM to 13:00-24: 00 PM. If you
press the SETTINGS button a third time, all timer settings are confirmed.
29