Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Connect the power lead (see the picture) with output III and make sure the installation and leakage
protection is at 1.5m above the ground.
2.
Repair access I, II and III are used for the repair (represent by the picture).
3.
The drainage device is installed in the hole, for repair, and needs to be in contact with the water
channels and controlled by a tap.
Electrics box
Client must install
protective covers
GENERAL REMARKS
Do not leave the spa in the sun without water and without its tarpaulin as it may damage the shell. Always cover
the spa with its tarpaulin when it is not in use, whether empty or full. Do not expose the spa to rain or snow. If
possible, build a shelter for the spa.
Do not try to open the electronic command box. It does not contain any parts which require maintenance.
Regularly empty the spa and refill it with clean water.
It is necessary to empty the ducts once a week (see emptying the ducts).
Clean the filter cartridge at least once a month and the filter once a week.
Before getting into the spa, it is advised to have a wash or a shower without soap and to wear a swimming
costume which has been rinsed in clean water to stop the water in the spa being contaminated by detergent or
soap.
Repaint the spa's outer wood every 1 or 2 years.
Good maintenance of the water quality will enable you to keep your SPA for a long time... for this, you simply need
to balance the water in your SPA and avoid a build up of lime scale which may damage your system.
WATER MAINTENANCE
It is very important that the water in the spa is always clean and clear. We advise you to change the water every 60
to 90 days depending on use. To do this, disconnect the Spa from the power supply and drain the water (see
Drainage, p.14). Make sure the plug is replaced properly and refill the spa with fresh water. If you are not sure,
here is a simple little calculation to know when to change the water: Litres of water in your spa ÷ (number of days
of use x the number of users) = the number of days you can keep the water in your Spa.
The terms used in a few words:
pH: The pH level must be between 7.2 and 7.6 with a pH of 7.4 being the ideal.
Abbreviation of power of hydrogen is the index to express the activity or concentration of the hydrogen ion in a
solution. The pH is acid at 0, neutral at 7 and alkaline at 14. It has a very great influence on the disinfection and must
be checked once a week.
Type of disinfectant used:
- Chlorinated products: 6.9 < pH < 7.7
- Bromine: 7.5 < pH < 8.2
19
Power
Power cord is installed
underground
Publicidad
