Publicidad
Idiomas disponibles
Idiomas disponibles
3. Assembly
EN
1. Remove the inner holders.
3. Follow the number order as illustrated to pre-tighten
the four screws with the included Allen key. Make sure
the handlebar is correctly installed and then tighten the
screws thoroughly.
Note: Examine the scooter every time before you ride it. Ensure that there are no loose or damaged parts.
06
2. Hold up the stem until it is completely in an upright
position. Then lift the safety lock, and push the quick-
release lever inward to the end. Install the handlebar
onto the stem.
Headlight Facing Forward
4. Once the scooter is assembled, check if it can be
turned on/off properly. Press the power button to turn
the scooter on, and then press and hold the power
button for 2-3 seconds to turn it off.
4. Connect with Mi Home/Xiaomi Home App
For your safely, the scooter will keep beeping when turned on and is limited to 10 km/h before being
activated. When the scooter is used for the first time, it must be activated via the Mi Home/Xiaomi Home
app. Once the scooter is activated, the beeping will stop and the speed restriction will be lifted.
1. Scan the QR code on the label attached to the control
panel, on the right side of the deck, or on the back cover
of the user manual to download the Mi Home/Xiaomi
Home app.
Notes:
The QR code is unique to your scooter, please keep it safe.
·
When connecting the scooter to the Mi Home/Xiaomi Home app, place your phone to the scooter as close as
·
possible to make sure it is within the effective Bluetooth range.
If change the account, delete the scooter from the account it is paired with first, then reconnect the scooter with the
·
Mi Home/Xiaomi Home app.
Reset Bluetooth
Make sure the scooter is turned on. Squeeze the brake lever, and press the power button 5 times to reset. When the
scooter beeps, it has been reset successfully.
Restore Factory Settings
Make sure the scooter is turned on. Squeeze the brake lever, and simultaneously press and hold the power button for 7
seconds. When you hear a beep, the scooter has been restored to factory settings. This operation will completely delete
the data stored in the scooter, please proceed with caution.
Note: The scooter cannot be restored to factory settings during riding or when locked.
2. Open the Mi Home/Xiaomi Home app. Tap "+" on the
top right corner and open "Scan" to scan the QR code
again. Then follow the instructions in the app to add the
scooter.
EN
07
Publicidad
