Assembly - Attaching The Fan Blades; Attaching The Fan Blades - HAMPTON BAY BAYWOOD Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
5
Mounting the fan
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the canopy (B) with the two
screws (GG) and alignment post (KK) in the mounting
bracket (A).
□
Push up the canopy (B) and turn clockwise until the
alignment post (KK) engages to the round hole and the
screws (GG) engage to the key slots.
□
Firmly tighten the two mounting screws (GG).
□
Install the decorative bottom cover (C) by aligning the cover
slots with screws in the bottom of the canopy (B). Rotate
the decorative bottom cover (C) clockwise to lock in place.

Assembly - Attaching the Fan Blades

1

Attaching the fan blades

□
Attach the blade (I) to the blade bracket (J) using the screws
(FF) provided. Please note that the rubber washers are
preattached to the blade bracket (J). Insert a screw into the
blade bracket (J). Repeat for the two remaining screws (FF).
□
Tighten each screw securely.
□
Fasten the blade assembly to the motor by inserting the
alignment post into the slot on the bottom of the motor and
tighten the motor screws. Please note that the motor screws
are pre-attached into the blade arm.
□
Repeat steps 1-3 for the remaining blades.
KK
FF
10
GG
I
J
A
D
B
C
E
F