Assembly Aspire Pe5-P4A; Operation - Husqvarna Aspire P5-P4A Manual De Usuario

Introduction
WARNING:
safety chapter before you assemble the
product.
To attach the pruner to the telescopic
shaft
1. Attach the pruner (A) to the telescopic shaft (B). The
pruner must move into the holder on the telescopic
shaft easily, if not, it is not installed correctly. (Fig.
47)
2. Tighten the knob (C).
Note:
When the pruner is attached to the
telescopic shaft, the user interface of the pruner is
disconnected.
To adjust the length of the telescopic
shaft
1. Loosen the screw handle on the shaft (A). (Fig. 48)
2. Adjust the shaft to an applicable length.
3. Tighten the screw handle (B).
To install the hook on the wall
• Install the hook indoors.
To do a function check before you use
the product
1. Examine the air intake for dirt and damage. Remove
dirt and unwanted material from the product with a
brush.
2. Tighten all nuts and screws.
3. Make sure that the pruner is attached correctly.
4. Examine the pruner for damages, for example,
cracks. Replace pruner if it is damaged.
5. Make sure that the covers are attached correctly and
not damaged.
6. Make sure that the product operates correctly.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
1867 - 004 - 19.09.2022

Assembly Aspire PE5-P4A

Read and understand the

Operation

Before you use the battery,
• Keep the hook out of sunlight and in ambient
temperature of -10°C to 70°C.
• Install the hook on a drywall, wood or concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
• Install the hook on the wall with the 3 screws (A).
Use wall plugs (B) if it is necessary.
CAUTION:
screws are applicable for your wall type.
a) For Aspire P5-P4A: (Fig. 49)
b) For Aspire PE5-P4A: (Fig. 50)
• Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
To hang the product on the hook
• Hang the pruner on the hook as shown in the
illustration. (Fig. 51)
• Hang the pole on the hook as shown in the
illustration. (Fig. 52)
Keep the battery and the battery charger in correct
ambient temperatures.
Ambient temperature
Operation of the -20 °C – 50 °C
battery in the
product
Charging of the 0 °C – 45 °C
battery
To charge the battery
Charge the battery before the first use.
Note:
The battery does not charge if the battery
temperature is more than +35 °C.
1. Connect the power cord for the battery charger in a
grounded mains.
Make sure that the wall
Make sure that the
401