Descargar Imprimir esta página

To Use The Correct Chain Oil; To Fill The Fuel Tank; To Use The Product - Husqvarna 525P4S Manual De Usuario

Ocultar thumbs Ver también para 525P4S:

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.

To fill the fuel tank

1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed. Use a fuel container with an anti-spill
valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and fuel source before starting.
CAUTION:
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.
To do a run-in
During the first 10 hours of operation, do not apply
full throttle without load for extended periods.
703 - 008 - 02.11.2022
Do not mix fuel for more
Contamination in the tanks

To use the correct chain oil

WARNING:
which can cause injury to you and the
environment. Waste oil also causes damage
to the oil pump, the guide bar and the saw
chain.
WARNING:
if the lubrication of the cutting equipment is
not sufficient. Risk of serious injury or death
to the operator.
WARNING:
that lets the fuel run out before the chain
oil. Use the correct chain oil for this safety
function to operate correctly. Speak to your
servicing dealer when you select your chain
oil.
Note:
This product has an automatic chain lubrication
system. You can also adjust the oil flow. Refer to
adjust chain lubrication on page 23 .
Use Husqvarna chain oil for maximum saw chain
life and to minimise environmental damage. If
Husqvarna chain oil is not available, we recommend
you to use a standard chain oil.
Use a chain oil with good adherence to the saw
chain.
Use a chain oil with correct viscosity range that
agrees with the air temperature.
CAUTION:
runs out before the fuel. In temperatures
below 0°C/32°F some chain oils become
too thick, which can cause damage to
the oil pump components.
Use the recommended cutting equipment. Refer to
Accessories on page 25 .

To use the product

Hold the product as close to your body as possible to
get the best balance. Use the harness to support the
weight of the machine and make it easier to handle.
Make sure that the tip does not touch the ground.
Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
Always slow the engine to idle speed after each
working operation. Long periods at full throttle
without any load on the engine can lead to serious
engine damage.
Always work at full throttle.
Do not use waste oil,
The saw chain can break
This product has a function
To
If the oil is too thin, it
13

Publicidad

Solución de problemas

loading

Este manual también es adecuado para:

525p5s