Descargar Imprimir esta página

The Engine Starts But Stops Again; Transportation, Storage And Disposal; To Prepare Your Product For Long-Term Storage - Husqvarna 525P4S Manual De Usuario

Ocultar thumbs Ver también para 525P4S:

Publicidad

Idiomas disponibles

Idiomas disponibles

Check
Spark plug and cylinder.

The engine starts but stops again

Check
Fuel tank
Air filter
Transportation and storage
For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
Always use approved containers for storage and
transportation of fuel.
Empty the fuel and chain oil tanks before
transportation or before long-term storage. Discard
the fuel and chain oil at an applicable disposal
location.
Use the transportation guard on the product to
prevent injuries or damage to the product. A saw
chain that does not move can also cause serious
injuries.
Remove the spark plug cap from the spark plug.
Attach the product safely during transportation.
24
Possible cause
The spark plug is dirty or wet.
The spark plug electrode gap is in-
correct.
The spark plug is loose.
Engine is flooded because of repea-
ted starts with full choke after igni-
tion.
Possible cause
Incorrect fuel type.
The air filter is clogged.

Transportation, storage and disposal

Procedure
Make sure that the spark plug is dry
and clean.
Clean the spark plug. Make sure that
the electrode gap is correct, refer to
Technical data on page 25 . Make
sure that the spark plug has a su-
pressor.
Tighten the spark plug.
Remove and clean the spark plug.
Put the product on its side with the
spark plug hole away from you. Pull
the starter rope handle 6-8 times. As-
semble the spark plug and start the
product. Refer to
on page 15 .
Procedure
Empty the fuel tank and fill it with correct fuel.
Clean the air filter.
To prepare your product for long-term
storage
1. Stop the product and let it become cool before you
disassemble it.
2. Disassemble and clean the saw chain and the
groove in the guide bar.
CAUTION:
guide bar are not cleaned, they can
become rigid or blocked.
3. Attach the transportation guard.
4. Clean the product. Refer to
for instructions.
5. Do a complete servicing of the product.
To start the product
If the saw chain and
Maintenance on page 16
703 - 008 - 02.11.2022

Publicidad

Solución de problemas

loading

Este manual también es adecuado para:

525p5s