Machine Information; Technical Specifications - VONROC CS505AC Traducción Del Manual Original

EN
have become fragile even if you cannot see any
ostensible damage.
6. Before you begin cutting, do a test run, i.e. take
a step back, switch on the motor and ensure
that the disc is functioning correctly. After chan-
ging the disc, let the saw run for three minutes;
thereafter, before doing any routine work, let it
test-run for one minute.
7. Whilst the machine is running, never try to
remove a work piece or to clamp a work piece
in. Always wait until the disk stops turning
completely before removing any work piece or
change the settings.
8. Before installing the disc, always inspect the
resin and rubber treated disc for shearing.
9. Always cross-check the maximum operating
speed of the disc cutting saw with the maxi-
mum permitted speed of the motor. Never ex-
ceed the maximum permitted operating speed
indicated on the disc.
10. Never try to mount a disc onto the machine by
force, or to change the size of the axles. Never
use discs which do not fit. Only use discs which
fit the machine.
11. Do not attempt to attach saw blades to the
machine, as it is not designed to cut wood.
12. Do not start cutting until the motor has reached
full speed.
13. If, while operating the machine, the disc no
longer turns or the motor sounds overloaded,
switch off the machine immediately.
14. Keep easily flammable or fragile objects away
from the machine. The machine operator must
avoid letting his or her hands, face or feet come
into contact with the sparks caused when cutting.
15. Position your machine firmly on a flat, even
surface.
16. Only operate the machine at the voltage stated
on the nameplate.
17. Never touch a sawn-off workpiece, always let it
cool down first.
18. Never attempt to cut workpieces which exceed
the permitted size.
19. During cutting, never position yourself in the
direction of cutting. Always remain to one side.
20. Always leave safety devices installed.
21. Always ensure that you cut slowly and carefully.
Avoid applying the disc to the workpiece with a
jerky motion.
22. Never push the workpiece towards the disc
while holding it in your hands. Always use the
8
clamp to fix the workpiece.
23. Keep hands away from the cutting disk. Never
cut work pieces where manual support is nee-
ded closer than 15cm from the rotating disk.
24. Make sure the work piece is properly supported.
25. Never use cutting fluids. These fluids could
ignite or cause electrical shock.
26. Do not cut cast-iron materials.
27. Do not cut plastics, wood or synthetic materials.
28. Do not cut magnesium.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The chop saw has been design for cutting steel
materials in various shapes.

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
Rated speed
Saw blade dimensions
Sound pressure L
PA
Sound capacity L
WA
Vibration a
h, AG
Weight
Max. cutting capacity at 90°
- Rectangular
- L shape
- Circular
CS505AC
220V-240V~
50/60Hz
2.300 W
4300/min
Ø 355mm x Ø 25.4mm
92 dB(A) K=3
105 dB(A) K=3
2.90+1.5 m/s²
15.8kg
115mm x 125mm
135mm x 135mm
Ø 125mm
WWW.VONROC.COM