To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna 320iHD60 Manual De Usuario

WARNING:
front of the cutting equipment does not
touch the ground.
• Use the 3 rear handles to operate the product at
different angles.
• Be careful and operate the product slowly.
To clear material from the blades
1. Press the reverse button.
2. Press 2 power triggers. The blade operates in the
opposite direction momentarily.
3. Press the power triggers again. The blade operates
in the usual direction.
4. If it is necessary, do step 1-3 again.
To temporarily increase the blade speed
1. Start the product. Refer to
page 12 .
2. Press the boost button to get the maximum blade
speed. The LED comes on.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
1777 - 006 - 09.06.2022
Make sure that the
To start the product on

Maintenance

Read and understand the
3. Release the boost button to use the product with the
initial blade speed.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
45 seconds.

To stop the product

1. Release the power trigger or the power trigger
lockout.
2. Press the start/stop button until the green LED goes
out.
3. Press the release buttons on the battery and remove
the battery.
WARNING:
you do maintenance on the product.

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product.
Remove the battery before
13