ASHDOWN ENGINEERING - DOUBLE DRIVE
REAR PANEL
DIRECT INJECT (D.I.)
A balanced D.I. Is provided on a latching XLR socket. This is Post E.Q. and effects
signal. The output signal from this XLR socket is set to a level and impedance
suitable for connecting directly into the input of a mixing desk for either Direct
Injection into the PA system or for recording. This must ONLY be used into a
balanced input, it is not intended for any other type of connection.
JACK INPUT
Use this to plug your instrument cable in or plug in from another pedal output.
JACK OUTPUT
This is a jack output to your amp or another pedal on your board.
DOUBLE DRIVE
USER GUIDE
SPECIFICATIONS:
Inputs
Input
Outputs
D.I.Output
Power Supply
2.1mm Plug 9V Centre pin NEGATIVE @ 100 mA.
Best results will be obtained with a LINEAR regulated supply (ie transformer type),
the use of switching type adapters may lead to the introduction of unwanted noise.
IMPORTANT! Use correct POLARITY Power Supply, the use of the wrong power
supply will invalidate the warranty and repairs required due to the use of the wrong
supply may incur a charge.
Impedance - 3.9M ohms
Input impedance 100k
420 ohms balanced , Transformer isolated, optional ground lift
USER GUIDE