Ashdown Engineering GEEZER BUTLER PEDAL OF DOOM Guia Del Usuario página 3

ASHDOWN ENGINEERING - PEDAL OF DOOM
TOP PANEL
VU METER 1
This is used to monitor the input level of your instrument. The Left Blue LED lights up in the VU
when E.Q. 1 is set and the Right Blue LED when E.Q. 2 is set.
VU METER 2
This is used to monitor the output level of the drive (Doom). The VU Blue LED lights up when the
Doom is engaged.
PEDAL OF DOOM
USER GUIDE
OUTPUT
This is used to set the overall output of the pedal, set to off and no sound will be heard.
BASS / LO MID / HI MID, E.Q. CHANNEL 1 (Left hand side)
The 3-band independent E.Q. can be used to dial in a tone for E.Q. Channel 1.
TREBLE
This controls the treble and is shared with E.Q. channel 1 & 2.
BASS / LO MID / HI MID, E.Q. CHANNEL 2 (Right hand side)
The 3-band independent E.Q .can be used to dial in a tone for EQ Channel 2.
DOOM
This dials in the amount of drive you want. From a small amount of edge to your tone to a world
ending distorted overdrive, this has you covered. CAUTION! Handle the DOOM level with care!
DOOM VOL
Sets the output level of your drive, when set to off and Doom is engaged (Blue LED light will be on
in the VU meter) no sound will be heard. Use this to match the volume of your amp or add a little
gain for a boost.
EQ 1/2 SWITCH
Use this foot switch to change between E.Q. setting 1 and E.Q. setting 2.
DOOM SWITCH
This foot switch engages the DOOM!!!
GROUND LIFT SWITCH
The ground lift switch eliminates unwanted hum and buzz if you are plugging into noisy
mains power.
USER GUIDE