Jack Input - Ashdown Engineering GEEZER BUTLER PEDAL OF DOOM Guia Del Usuario

ASHDOWN ENGINEERING - PEDAL OF DOOM
REAR PANEL
DIRECT INJECT (D.I.)
A balanced D.I. Is provided on a latching XLR socket. This is Post E.Q. and effects signal. The output
signal from this XLR socket is set to a level and impedance suitable for connecting directly into
the input of a mixing desk for either Direct Injection into the PA system or for recording. This must
ONLY be used into a balanced input, it is not intended for any other type of connection.

JACK INPUT

Use this to plug your instrument cable in or plug in from another pedal output.
JACK OUTPUT
This is a jack output to your amp or another pedal on your board.
PEDAL OF DOOM
USER GUIDE
SPECIFICATIONS:
Inputs
Input
Outputs
D.I.Output
Equalisation
Bass
Lo Mid
Hi Mid
Treble
Power Supply
2.1mm Plug 9V Centre pin NEGATIVE @ 100 mA.
Best results will be obtained with a LINEAR regulated supply ( ie transformer type ),the
use of switching type adapters may lead to the introduction of unwanted noise.
IMPORTANT! Use correct POLARITY Power Supply, the use of the wrong power supply
will invalidate the warranty and repairs required due to the use of the wrong supply may
incur a charge.
Impedance - 3.9M ohms Input impedance 100k
420 ohms balanced, Transformer isolated, optional ground lift
Passive 0-100%
Passive 0-100%
Passive 0-100%
Passive 0-100%
USER GUIDE