MaxPro PROFESSIONAL MPBBG150 Manual De Instrucciones página 5

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into
account the working conditions and the work to be performed. Use of the power tool for operations
different from those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
SAFETY INSTRUCTION FOR BENCH GRINDER
Symbols
Observe the dimensions of the saw blade. The hole diameter must match the tool
spindle without play.
Danger Area! Keep hands far away from the cutting area while the machine is running.
Keep bystanders away.
Wear safety goggles.
• Store the machine in a safe manner when not being used. The storage location must be dry and lockable.
This prevents the machine from storage damage, and from being operated by untrained persons.
• Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug
when the cable is damaged while working. Damaged cables increase the risk of an electric shock.
• Check the cable regularly and have a damaged cable repaired only through an authorised customer
service agent for Bosch power tools. Replace damaged extension cables. This will ensure that the safety of
the power tool is maintained.
• Keep handles dry, clean, and free from oil and grease.Greasy, oily handles are slippery causing loss of
control.
• Connect the machine to a mains supply with proper earthing connection. Socket outlet and extension
cable must be equipped with an operative protective conductor.
• Do not use accessories which are not specifically designed and recommended by the tool manufacturer.
Just because the accessory can be attached to your power tool, it does not assure safe operation.
• The rated speed of the accessory must be at least equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed can break and fly apart.
• Do not use a damaged accessory. Before each use, check the grinding wheel for chips and cracks. If the
machine or application tool is dropped, inspect for damage or install an undamaged application tool. After
inspecting and installing the application tool, position yourself and bystanders away from the plane of the
rotating application tool and run the power tool at maximum no-load speed for one minute. Damaged
application tools will normally break apart during this test time.
• Use the machine only with the spark guard. Sparks being expelled can injure your eyes or set objects in
the vicinity on fire.
• When grinding, tilt down the spark guard as far as possible. Sparking occurs when grinding metal.
• Regularly check the clearance between the workpiece supports as well as the holder of the spark guard
to the grinding wheel, and readjust as required. The clearance to the grinding wheel may not exceed 2 mm.
When the clearance is larger, you are not sufficiently protected against sparking. The workpiece can be
drawn in by the rotational motion of the grinding wheel and lead to injuries.
GB 4