Operation Tips; Cutting Tips; Line Cut-Off Blade; Change To The Edging Mode - GreenWorks 21332 Manual Del Operador

9.6

OPERATION TIPS

WARNING
Keep clearance between the body and the machine.
WARNING
Do not operate the machine without guard in place.
Do these tips when you use the machine
• Keep a firm hold with the two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
9.7

CUTTING TIPS

• Tilt the machine toward the area to be cut. Use the
tip of the cutting line to cut grass.
• Move the machine from right to left to prevent
thrown debris from hitting the operator.
• Do not cut in the danger area.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
English
DANGER
AREA
9.8

LINE CUT-OFF BLADE

This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line
to ensure a consistent and efficient cut diameter.
Advance line whenever you hear the engine running
faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep line long enough to advance properly.
9.9

CHANGE TO THE EDGING MODE

You can change the trimmer to an edger to keep
patios, driveways and sidewalks well groomed.
1. Stop the machine.
2. Push on the edge button and turn the trimmer head
90 degrees until the trimmer head locks into
position.
3. Release the edge button (8).
90°
9
DIRECTION OF
ROTATION
BEST CUTTING
AREA
NOTE
EN