Emergency Release - Ruroc ATLAS 4.0 Manual De Instrucciones

EMERGENCY RELEASE

Emergency release loops are found on the
underside of the helmet, pull on the loops to
break the popper connection, releasing the
cheek padding from the helmet. These tabs
are used for emergency use only. Excessive
use (not in an emergency) may damage
the cheekpad assembly. Only use when
needed.
ATLAS COMFORT LINER
Every ATLAS comes with a headliner &
cheek-pads that are both removable &
washable. Not only is this component
protective against cold air but it also reduces
wind-noise. To remove your headliner &
cheek-pads follow these steps: disconnect
the poppers on the cheek-pads and back of
the headliner. Then disconnect the plastic
band at the front of the headliner. Lastly,
gently pull out the liner making sure to help
the chin strap through the cheek pads and
free the plastic wings on the cheekpads
from the internal clips. To reassemble simply
follow these steps in reverse.
LINER WASHING
You may want to wash your comforliner from
time to time to keep it feeling fresh.
1. Firstly remove the items you wish to wash
from the helmet.
2. Unzip the back of the cheek pad.
AT4_MAN_01-00
the fastener is just as easy: simply pull the red
tab to release. To tighten, pull the strap through the
adjustment buckle. To loosen, lift the buckle away from the
head, releasing tension on the
strap and then adjust to fit.
Visit our 'how to' guides
more information
05
FIDLOCK BUCKLE
The Fidlock is engaged by moving the
top strap (with the metal buckle) towards
the bottom fastener strap. Once in
position, both parts magnetically lock and
engage securely in the groove. Opening
for
Carefully remove the foam from inside of
the pad, without damaging the foam. Hand
wash the cheek pad material and foam
insert in cold water with a mild detergent.
Rinse thoroughly and dry out of direct heat
or sunlight. Exposure to heat / sun may
damage / fade the material. Once fully dry,
carefully re-insert the foam into the cheek
pad. The emergency tab can be pulled tight
at this time (to sit flat) if loose.
3. Headliner and chin curtain care; hand
wash in cold water with a mild detergent.
Rinse thoroughly and dry out of direct head
or sunlight. Exposure to heat / sun may
damage / fade the material. Only assemble
into helmet once fully dry.
Visit our 'how to' guides for more information.