Electrical Connection - DeLonghi EX Serie Manual De Instrucciones

INTRODUCTION
Thank you for choosing a De'Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.
DESCRIPTION
Description of the appliance (see page 3 - A)
A1 air outlet flap
A2 control panel
A3 handles
A4 castors
A5 dust filter
A6 air intake grille
A7 air exhaust hose housing
A8 air intake grille
A9 power cable
A10 drainage hose with cap
A11 remote control compartment
A12 remote control signal receiver
Description of the accessories (see page 3 - B)
B1 adapter for window bracket
B2 air exhaust hose
B3 hose adaptor
B4 additional window bracket
B5 window bracket with wing nut
B6 window bracket cap
B7 remote control
B8 end of season accessories bag (not on all models)
B9 end of season dust cover (not on all models)
B10 stripping foam

ELECTRICAL CONNECTION

Before plugging the appliance into the outlet, check that:
• The outlet's power supply corresponds to the value
indicated on the rating label on the back of the appliance.
• The outlet and electrical circuit are adequate for the
appliance.
• The outlet is a 3-hole grounded outlet
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a qualified professional only.
USE
The instructions below will enable you to prepare your air con-
ditioner for operation as efficiently as possible. Before use, make
sure the air intake and air outlet flap are unobstructed.
. If this is not
6
Please note: This appliance is provided with an auto-evapora-
tion feature for condensate removal during cooling and dehu-
midifying modes.
AIR CONDITIONING INSTALLATION
For optimal results see the figures below for the
suggested minimum distances.
20 in
50 cm
20 in
50 cm
DOUBLE-HUNG WINDOW
• Place the window bracket (B5) in the window sill, extend
the bracket fully within the window frame (fig. 1).
6
• Fix the bracket into place by tightening the wing nut (fig.
2). Attach the provided stripping foam (B10) to the top of
the window bracket and then lower the window onto the
bracket (should the window bracket be too large for the
window the plastic can be cut with a saw by a qualified
professional).
3
1
5
20 in
50 cm
20 in
20 in
50 cm 50 cm
1
4
2
36 in
32 in
90 cm
80 cm