TMEZON MZ-VDP-NE202 Manual De Instrucciones página 6

Specification for doorbell
Sensor area
1/2.9"
Resolution
1920 X1080
PAL/NTSC
Standard
View angle
150
Standby current
Max60mA
Work current
Max200mA
Power supply
DC12V
Work temperature -40~+50 C
Max 200PCS
Password capacity
RFID card capacity Max 200PCS (IC card, 13.56Mhz)
Max 200PCS
Fingerprint capacity
Install the outdoor doorbell
Outdoor installation
120
1:Please be far from the devices with intense radiation: TV, DVR, etc.
2:Do not disassemble privately to avoid the electric shock.
3:Do not drop, shake or knock the device, otherwise will damage the elements.
4:Choose the best position to install, the horizontal view is 150cm.
5:Please power down before installation.
6:Keep at a distance of more than 30cm with AC power to avoid interference.
7:Away from the water, magnetic field and chemicals.
GB - 9 support@tmezon.com
Method A
Hatch
Flush casing
Method B
Hole
Hatch
Angle bracket
Flush casing
Wiring diagram for outdoor doorbell
Model: MZ-VDP-NE201
Independent power interface for doorbell (12V) ---optional
If the distance is too long and not provide enough power to
unlock the door opener, you can add this independent power
supply (12V) for the doorbell separately.
Power supply control
NO
CONTROL-
CONTROL+
COM
Push
MONITOR1
GND
12V
COM
COM
LOCKTime
NC
2S-10S
NO
SPK(VOL)
NO
NC
NO Lock
NC Lock
Electric mortise lock
Electronic lock
Magnetic lock
Cathode lock
GB - 10
DOOR
EXIT
Cathode lock
GND
Lock-V+
Pulse electric lock
a Setting button: Add card mode
or Reset mode
1) Mode to add RFID card:
In standby mode, short press the
setting button, enter the mode to add
RFID card, swipe RFID card in the card
swiping area, you can add a card, you can
Repeat the RFID card to add more RFID
cards, and then press the set button to
exit the mode to add RFID card.
2) Reset mode: In standby mode,
press and hold the setting button for
3 seconds to enter reset mode, then
press the setting button three times,
you will hear a sound, all card numbers
will be deleted, and it will return to
standby mode.
support@tmezon.com