Installation; Use - Qilive Q.5824 Manual Del Usuario

Idiomas disponibles

4. INSTALLATION

This product can be mounted onto a flat, even wall for storage or charging. To do so:

1. Insert the cable into the groove on the wall bracket (14) and turn it by 90° to lock it in place.

2. Select an installation position located in the proximity of the electrical outlet.

3. Fix the provided wall bracket (14) using suitable screws and wall plugs (not supplied).

Make sure not to pinch the power cable during installation.

•

IMPORTANT: Do not drill into any pipes or mains cables beneath the surface during

mounting holes preparation. The fixing point(s) must be capable of supporting the full

weight of the product.

5.1 Assembly

1. Insert the HEPA filter (12) into the filter holder (13) and turn until locked.

2. Insert assembled parts into the dust container (9).

3. Fix the dust container (9) onto the main unit (10). Make sure it locks in place.

4. Insert the battery (16) into the main unit (10). Also make sure it locks in place.

5. Connect the extension tube (5) to the main unit (10).

6. Connect the motorized floor brush (7) or 2-in-1 tool (17) to the extension tube (5).

NOTE: The 2-in-1 tool (17) can also be directly connected to the main unit (10).

5.2 Charging

The battery needs to be charged when the last battery indicator (5) flashes.

1. Connect the provided power adapter (15) to a suitable electrical outlet.

2. Place the vacuum cleaner on the wall bracket (14).

3. The 3 battery indicators (3) flash in sequence during charging. The first charge should

take about 3-4 hours.

4. Once the product is fully charged, 3 battery indicators (3) light up steadily.

NOTE: The on/off key (1) is deactivated during charging process. Product cannot be switched

on.

5.3 Vacuuming

1. To switch the product on, press the on/off key (1). To switch off, press it again.

2. The battery indicators (3) light up steadily during operation. Each indicator corresponds to

a higher battery charge level.

3. Press the speed selection key (+) (2) to toggle between high and low vacuuming speed.

Tabla de Contenido