Before Starting The Equipment; Charging Procedure - EINHELL GC-CG 3,6/70 Li WT Manual De Instrucciones

Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Cut injuries are possible if no safety clothing
is used.
2. Lung damage if no suitable protective dust
mask is used.
3. Damage to hearing if no suitable ear protec-
tion is used.
4. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Charging the rechargeable battery
•
Connect the unit to the charger (Figure 3).
•
Check that your mains voltage is the same as
that marked on the rating plate.
•
The time it takes to fully recharge an empty
battery is approximately 3 to 5 hours. The
temperature of the battery pack might rise
slightly during the charging operation. This is
normal.

Charging procedure

Plug the charger in a socket-outlet; a red LED
(Fig. 3/Item A) lights up to indicate that charging is
in progress. The battery pack is being charged.
Charging completed
The red LED (Fig. 3/Item A) goes out. A green
LED lights up in its place (battery charged).
Battery does not charge up
If the battery fails to charge, please check
- whether there is voltage at the socket outlet.
- whether there is good contact at the charging
contacts.
- whether the red LED and the green LED (Fig.
3/ Item A) light up at the same time. This can
happen, for example, if the battery tempera-
ture becomes too low or too high. Place the
unit in storage at room temperature for one
day.
Anl_GC_CG_3_6-70_Li_WT_SPK13.indb 16 Anl_GC_CG_3_6-70_Li_WT_SPK13.indb 16
GB
If you still fail to charge the battery pack, please
return the complete tool together with the battery
charger to our Customer Service Center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Warning! Any foreign bodies must be com-
pletely cleared away from the area to be
worked on.
Warning!
The switching devices installed on the tool
by the manufacturer are not allowed to be
removed or bypassed, e.g. by fi tting a swit-
ching button to the handle, as this may result
in risk of injury and the tool will no longer
switch off automatically.
6. Operation
6.1 Using the equipment as grass shears
Allow the grass shears to glide over the ground.
The best cutting performance is achieved on dry
lawns.
The blade guard hood must be pushed over the
blade when the unit is not being used.
The grass shears is supplied ready assembled.
(Fig. 4) Remove the blade guard hood (Item 6).
6.1.1 Switching on/off .
1. (Fig. 4) To switch on, press the safety lock-off
(Item 3) and press the On/Off switch (Item 4)
at the same time.
2. To switch off , let go of the On/Off switch.
- 16 -
21.06.2022 09:20:00 21.06.2022 09:20:00